revised 11/21/2011 www.phihong.com psm500 500w 1u rps and bulk n+1 with active pfc features ? selv output with 1500 v ac isolation ? diagnostics ? 500 watts x 3 in 1u 19? rack ? full protection ocp, ovp, otp ? hot plug n+1 ? 85-256v ac with active pfc applications ? power over ethernet ? network redundant power source ? telecommunications ? servers safety approvals ? cul/ul ? tuv ? ce mechanical characteristics ? length: 300mm (11.81in) ? height: 41mm (1.61in) ? width: 107mm (4.21in) ? weight: 1.8kg (4lb.) output specifications note: (1) measured with by-pass capacitors 0.1uf/10uf at output connector terminal and oscilloscope set at 20mhz. phihong is not responsible for any error, and reserves the right to make changes without notice. please visit our website at ww w.phihong.com for the most up-to-date specifications and contact information. model dc output voltage load ripple (1) p-p (max) regulation min. max. line load psm500-210 50v (main) 0a 10a 1% 0.5v 12v (standby) 0a 1.5a psm500-216 56v (main) 0a 9a 1% 0.5v 12v (standby) 0a 1.5a
poe100u characteristics www.phihong.com input: ac input voltage range 85 to 264vac ac input current 6a (rms) maximum for 115vac 3a (rms) maximum for 230vac ac input line fuse 10a/ 250v leakage current 3.5ma maximum @ 254vac 60hz ac input frequency 47-63hz ac inrush current 30a (rms) maximum for 115vac 60a (rms) maximum for 230vac output: efficiency 83% (typical) at maximum load, and 115vac/230vac hold-up time 10ms min. 120vac and maximum load over voltage protection ov set at 57~60v ? latching over current protection protection against short circuit. isc max 110%-140% full load current. the 50v, 56v can operate in current mode till short circuit and can be shorted permanently without damage. environmental: temperature operation 0 to +50c non-operation -30 to +70c humidity operation 8 to 90% emc fcc class b en55022 conducted class b *with external filter (*measured with y capacitors 0.01uf/400vat main output connector terminal from v to unit chassis) en55022 conducted class b; radiated class a (using 3 x psm500-210, or -216 in rack psa1553-605) isolation test primary to secondary: 4242v dc primary to field ground: 2121v dc output to field ground: 2121 v dc immunity esd: en61000-4-2. level 3 rs: en61000-4-3. level 3 eft: en61000-4-4. level 2 surge: en61000-4-5. level 3 cs: en61000-4-6. level 3 voltage dips en61000-4-11 harmonic: en61000-3-2 feature: front panel led dc good, fault condition 50v enable/disable non latching ? remote on/off pin thermal shutdown latching fan fail latching load sharing 10% at full load isolated diode internal oring diode located on main (-) output section output connector molex p/n 15060141 or equivalent molex p/n 15249144 or equivalent (mating)
dimension diagram unit: mm (inch)
|
